Allied Telesis AT-S63 - Manual (Page 407)

AT-S63 Management Software Command Line Interface User’s Guide
407
migrationcheck This parameter resets a MSTP port, allowing it to send
MSTP BPDUs. When a MSTP bridge receives STP
BPDUs on an MSTP port, the port transmits STP
BPDUs. The MSTP port continues to transmit STP
BPDUs indefinitely. Set the migrationcheck parameter
to yes to reset the MSTP port to transmit MSTP BPDUs.
yes, on, true Enable migration check. The options
are equivalent.
no, off, false Disable migration check. The options
are equivalent.
Note
Each time a MSTP port is reset by receiving STP BPDUs, set the
migrationcheck parameter to yes, allowing the port to send MSTP
BPDUs.
Description
This command sets a port’s MSTP settings.
Examples
The following command sets the internal port cost to 1,000,000 and port
priority to 224 (increment 14) for Port 4:
set mstp port=4 intportcost=1000000 portpriority=14
The following command changes Ports 6 to 8 so they are not considered
edge ports:
set mstp port=6-8 edgeport=no
The following command returns Port 7 to the default MSTP settings:
set mstp port=7 default