Allied Telesis AT-S63 - Manual (Page 373)

AT-S63 Management Software Command Line Interface User’s Guide
373
SHOW STP
Syntax
show stp [port= port ]
Parameter
port Specifies the port whose STP parameters you want to
view. You can view more than one port at a time.You
can specify the ports individually (for example, 5, 7,
22), as a range (for example, 18-23), or both (for
example, 1, 5, 14-22).
Description
This command displays the current values for the following STP
parameters:
ˆ STP status
ˆ Bridge identifier
ˆ Bridge priority
ˆ Hello time
ˆ Forwarding delay
ˆ Maximum age timer
You can also use this command to view the following STP parameter
settings for a switch port:
ˆ Port cost
ˆ Port priority
ˆ Port STP state
Examples
The following command displays the switch’s STP settings:
show stp
The following command displays the STP settings for ports 1 to 4:
show stp port=1-4