ADC SG-1 User Manual
Sg-1 service gateway system
Table of contents
Document Outline
- Revision History
- Copyright
- Trademark Information
- Disclaimer of Liability
- About This Manual
- Overview
- Installation
- Command-Line Interface (CLI)
- Accessing the Command Line Interface
- Using the Command Line Interface
- First-Level Commands
- Showing a List of Available Parameters
- Using the ? command
- Using the show ? command
- Using the show version command
- Displaying the configuration in NVRAM
- Displaying Ethernet port configurations
- Displaying Ethernet Port Statistics
- Displaying SONET port status
- Displaying ATM Port Status
- Displaying User Status
- Displaying Routing Tables
- Displaying System Administrators
- Displaying System Parameters
- Displaying License Attributes
- Displaying VRRP attributes
- Displaying active GRE and IP-in-IP tunnels
- Displaying show mpls-labels commands
- Displaying show mpls l2transport vc commands
- Displaying a list of available write commands
- Using the copy-TFTP command
- Using the ping command to test network connectivity
- Using the reload command to restart the system
- Clearing Users
- Using the Traceroute Command
- Using the exit command
- Using Debug Mode
- Showing a List of Available Parameters
- Second Level Commands
- Using the configure command
- Banner Command
- Ethernet Commands
- Loopback Commands
- VLAN Commands
- Authentication Commands
- ATM Commands
- RADIUS Commands
- Access List Commands
- SNMP Commands
- Tunnel commands
- Timeouts Commands
- Native IP Commands
- Maximum Segment Size (MSS) Changing
- L2TP and PPP Commands
- DHCP Commands
- IGMP Commands
- Routing Command
- Using the IP route command
- Deleting an IP route line
- Using the ip default-gateway command
- Using the ip ospf interface command
- Using the ip ospf interface hello-interval command
- Using the ip ospf interface dead-interval command
- Using the ip ospf interface authentication command
- Using the ip ospf interface authentication-key command
- Using the ip ospf interface message-digest-key command
- Using the ip ospf area stub command
- Using the ip ospf advertise network command
- Using the mpls ip interface command
- Using the mpls l2transport interface command
- Using mpls l2transport route command
- Using mpls ip default-route command
- Using the vrrp command
- Using the vrrp preempt command
- Debug Commands
- SG-1 Vendor-Specific Attributes
- Overview
- User Group
- user:accounting sub-attribute
- user:orig-name sub-attribute
- user:auth-type sub-attribute
- user:action sub-attribute
- user: SSC-host sub-attribute
- user: service-name sub-attribute
- user:personal-site sub-attribute
- user:mac-address sub-attribute
- user:group sub-attribute
- user:max-allowed-sessions sub-attribute
- user:class sub-attribute
- user:eds-enc-key sub-attribute
- dhcp group
- protocol group
- service group
- route group
- vpdn group
- qos group
- dns group
- Redirection Server
- Using the system event logging information includes the Http URL requests.
- Using password command
- Using default-redirection-site command
- ORUP Commands
- Service Name Commands
- TFTP Commands
- Show Commands
- Ethernet Commands
- Default Gateway Commands
- Using Reload Command
- Write Commands
- Using Poweroff Command
- SNMP Commands
- Using Reset Configuration Command
- HTTP Commands
- Name Server
- Using Hostname Command
- Using EDS-URL-IDENTITY Command
- Using No EDS-URL-IDENTITY Command
- IP-IN-IP Commands
- Show User Commands
- Using Debug Protocol Command
- Using Rest Web Command
- Using Date Command
- Product Support
- Glossary
- Certification and Warranty