ADC SG-1 - Manual (Page 143)

June 30, 2006 Chapter 7: Second Level Commands
SG1-UM-8500-03 7-63
Using the no ip ospf advertise network command
This command deletes advertisement of a network.
Usage
no ip ospf advertise network
For parameters and examples, refer to “Using the ip ospf advertise network command” on page 7-62 .
Using the mpls ip interface command
This command enables MPLS forwarding of Ipv4 packets for a specific system interface. One limitation is that
currently the MPLS may be configured for one interface only of type VLAN or Ethernet.
Usage
mpls ip interface <Ethernet | VLAN | ATM > \
[\]
Parameter(s)
This is the SCC slot number; valid number range is 0 to 2.
This is the SCC port number; valid values are 1 or 2.
This is the SCC for ATM sub-interface number; valid number range is 1 to 4095.
Example(s)
Using the no mpls ip interface command
This command disables mpls forwarding of IPv4 packets from the system interface.
Usage
no mpls ip interface <Ethernet | VLAN | ATM > \
[\]
Host(config)# no ip ospf advertise network
Host(config)# mpls ip interface
Host(config)# mpls ip Ethernet 0\1
Host(config)# no mpls ip interface