beautypg.com

Using the interface atm command – ADC SG-1 User Manual

Page 98

background image

Chapter 7: Second Level Commands

June 30, 2006

7-18

SG1-UM-8500-03

Using the no pppoa enable command

The no pppoa enable interface command disables PPPoA negotiation for a specific interface in the system.

Usage

No pppoa enable interface \

For parameters see

Table 7-6

.

Using the interface atm command

The interface atm command defines the atm interfaces in the system.

• The command is accessible at the "configure terminal" menu.

• The command is only applicable with the SCC-ATM155 card.

• When MTU is configured to 1500, the write terminal command should not be used.

• IP address and loopback are not enabled for the PPP interface type.

• The routed type interface does not support unnumbered links.

Usage

Host(Config)# no pppoa enable interface

Host(config)# interface atm

interface atm \\ [type

tipoint |

routed point-to-point > |

routed-bridge > | loopback

face number>

routed-bridge-ppp > | loopback

interface number>

]

[mtu <1500 | 1544>]