Using the pppoa enable command, Table 7-5. pppoa enable interface parameters -17 – ADC SG-1 User Manual

Page 97

7-17

[loopback]

Places a logical loopback on the bridge-route interface.

Numeric value assigned to the bridge-route loopback.

[mtu]

Used to set the interface's Maximum Transmission Unit (MTU) (valid values are 1500 or 1544).

Example(s)

Using the pppoa enable command

This command enables PPPoA negotiation for a specific interface within the system.

Usage

pppoa enable interface \

Before enabling PPPoA, you must configure the correct port and the ATM interface.

Parameter(s)

Table 7-5. pppoa enable interface parameters

Example(s)

Host(config)# interface atm 2 \ 1 \ 1 type bridge-route point-to-point ip

192.168.10.1 255.255.255.0 mtu 1544

Added item

Host(config)#

Host(config)# pppoa enable interface

Parameter

Description

Legal values/range

Slot number.

1 - 2

Physical port number.

1 - 2

Sub-interface number.

1- 2000

Host(config)# pppoa enable interface 0 \ 1