ADC SG-1 - Manual (Page 118)

Chapter 7: Second Level Commands June 30, 2006
7-38 SG1-UM-8500-03
Parameter(s)
The Ethernet slot number (valid number range is 0 to 2). The Ethernet port number (1 or 2).
The Ethernet slot number (valid number range is 0 to 2), The Ethernet port number (1 or 2), and VLAN identifier,
sub-interface (valid number range is 1 to 4095).
This specifies the LDP IP address of the remote PE; it must be a valid IP address.
This is used to assign a VC ID to the virtual circuit between the system and the remote PE. Valid number range
1 – (2^32 –1).
Example 1:
Example 2:
The native-ip roaming command enables seamless roaming of users between SCCs. It enables the native-ip
roaming between SCCs share the same subnet.
Usage
No native-ip roaming
Example:
Host(config)# native-ip roaming
Host(config)# native-ip roaming interface Ethernet 0\2
Host(config)# no native-ip roaming
Host(config)# no native-ip roaming