Table 7-1. configure ethernet ports -4 – ADC SG-1 User Manual

Page 84

7-4

The operating mode of the interface to be configured (see

(mtu)

The maximum transmission unit. Select either:

• 1500 (default)

• 1544

Example 1

Example 2

Table 7-1. Configure Ethernet Ports

Host(config)# interface ethernet 0 \ 2 12.3.66.211 255.255.255.0 auto mtu 1500

interface ethernet 0 \ 2 12.3.66.211 255.255.255.0 auto mtu 1500

Note:

The system should refuse to assign an address to an Ethernet interface which is in the subnet of the

other Ethernet interface and indicates the reason.

Host(config)# interface ethernet 0\2 192.168.3.5. 255.255.255.0

Operation Error:

ethernet address is not valid

Note:

The system should ignore the interface ethernet command if the system is in Ethernet redundancy

mode. It will indicate a command failure to the system log and to the user interface (telnet).

Card Type

Slot\Port

Slot\Port 2

Gigabit Front I/O

0\1

Gigabit Rear I/O

0\2

0\3

Gigabit Front (PMC) I/O

1\1

1\2