ADC SG-1 - Manual (Page 136)

Chapter 7: Second Level Commands June 30, 2006
7-56 SG1-UM-8500-03
Usage
no ip default-gateway
Example(s)
When assigning a default-gateway that is not in the subnet of the primary or secondary Ethernet interfaces, the
system provides a warning.
Using the router command
This command defines the system default routing process. In cases where advertisement should take place and
there is no other higher priority definition, the system uses this definition. The routing modes include Routing
Information Protocol Version 2 (RIPv2) and Open Shortest Path First protocol (OSPF).
Usage
router
Example(s)
Using the router id command
This command defines the system router id.
Usage
router id < router ip>
Parameter(s)
OSPF router ID in IP address format.
Host(config)# no ip default-gateway
Host(config)# ip default-gateway 194.90.2.1
Operation Warning:
The default gateway is out of subnet
Host(config)# router
Host(config)# router ripv2
Host(config)# router ospf
Host(config)# router id