Qos:acl-down-mean-rate sub attribute, Qos:cos – ADC SG-1 User Manual
Page 192
Appendix A: SG-1 Vendor-Specific Attributes
A-34
General:
Format:
adc-avpair = "qos:acl-up-mean-rate=
Example:
adc-avpair = "qos:acl-up-mean-rate=acl1;128",
qos:acl-down-mean-rate sub attribute
The qos:acl-down-mean-rate sub-attribute specifies the average number of bits per second allowed to the user in
the downstream direction per a specified access list. It is sent in Access-Accept message and overwrites the current
access list downstream rate of the user. This attribute may be operated during the session lifetime (EDS).
General:
Format:
adc-avpair = "qos:acl-down-mean-rate=
Example:
adc-avpair = "qos:acl-down-mean-rate=acl1;256",
qos:cos
The qos:cos sub-attribute defines the class of service that should be set for a specified access list. The system sets
the defined COS value for all the session's packets that matched the access list. This attribute may be included
more than once in request or accept messages. The attribute is being ignored and not being saved by the system,
whenever a specified access list does not exist in the session's definitions.
General:
Format:
adc-avpair = "qos:cos=
Operation Mode:
Access-Accept message
Service-Accept message
Vendor-type:
92
Vendor-length:
1-128 + attribute-name length
Operation Mode:
Access-Accept message
Service-Accept message
Vendor-type: 93
Vendor-length:
1-128 + attribute-name length
Operation Mode:
Access-Accept message
Vendor-type:
94
Vendor-length:
1-16 + attribute-name length