Banner command, Ethernet commands, Configuring gigabit ethernet ports – ADC SG-1 User Manual
Page 83: Banner command -3 ethernet commands -3
Chapter 7: Second Level Commands
7-3
B
ANNER
C
OMMAND
Creating a Login Banner
You may create a greeting message or banner, to be displayed on the user's terminal when they log in. The banner
may be a string of up to 32 alphanumeric characters.
To set "Welcome to SG-1" as a banner:
At the second level command prompt, type: banner Welcome to SG-1 (then press ENTER).
Configuring Banner command
Usage
Host(config)# banner
Parameter
It is the Terminal greeting (maximum 32 characters).
Example
E
THERNET
C
OMMANDS
This section contains instructions for configuring service for Gigabit Ethernet cards installed in a SCG1664A/D.
Configuring Gigabit Ethernet ports
Use this command to configure service for Ethernet cards.
Usage
interface ethernet
<1500|1544)>
Parameter(s)
The port number that you want to configure.
The slot number that you want to configure (see table 7-1)
The ip address to be assigned to the interface.
The valid subnet mask for the configured ip address.
Host(config)# banner command
Host(config)# banner ADC
Host(config)# interface ethernet