ADC SG-1 User Manual
Page 116
Chapter 7: Second Level Commands
7-36
Example(s)
The system should disable the native-ip enable command in case Native IP capability is not licensed (set to off). The
system should report an operation error with the following message format:
Using the no native-ip enable command
It deletes a native ip enabled configuration.
Usage
no native-ip enable interface [<Ethernet
ATM tion> Parameter(s) This is the Ethernet slot number (valid number range is 0 to 2). This is the Ethernet port number (1 or 2). This is the Ethernet slot number (valid number range is 0 to 2). This is the Ethernet port number (1 or 2), and VLAN This is the Ethernet slot number (valid number range is 0 to 2), Ethernet port number (1 or 2), and VLAN identifier, This is the tunnel interface identifier (valid number range is 1 to 300). This specifies the LDP IP address of the remote PE; it must be a valid IP address. This is used to assign a VC ID to the virtual circuit between the system and the remote PE. Host(config)# native-ip enable interface Ethernet 0 \ 1 Host(config)# native-ip enable interface ATM 2 \ 2 \ 43 Host(config)# native-ip enable interface VLAN 0 \ 1 \ 45 Host(config)# native-ip enable interface 0\2 Operation Error: License is required Host(config)# no native-ip enable interface Host(config)# no native-ip enable VLAN 1\1\9
identifier (valid values are 1 to ?).
sub-interface (valid number range is 1 to 4095).