ADC SG-1 - Manual (Page 115)

June 30, 2006 Chapter 7: Second Level Commands
SG1-UM-8500-03 7-35
Example(s)
Using the native-ip enable command
This command enables native ip service on a specific interface.
It enables the native IP for a specific VLAN or interface.
Phase 1 should include Ethernet interface and VLAN-Id only.
Phase 2 should include interface atm.
Usage
native-ip enable interface [ | VLAN |
ATM | tunne | l2transport
tion>
Parameter(s)
This is the Ethernet slot number (valid number range is 0 to 2) and Ethernet port number (1 or 2).
This is the Ethernet slot number (valid numbers 0 to 2), Ethernet port number (1 or 2), and VLAN identifier (1 to ?).
This is the Ethernet slot number (valid number range is 0 to 2), Ethernet port number (1 or 2), and VLAN identifier
(sub-interface valid number 1 to 4095).
This is the tunnel interface identifier. Valid number range is 1 to 300.
This specifies the LDP IP address of the remote PE. It must be a valid IP address.
This assigns a VC ID to the virtual circuit between the system and the remote PE.
Host(config)# native-ip def-service-auth werbcvxsaq
Host(config)# native-ip enable interface