What to do next, What to do next -2 – ADC SG-1 User Manual
Page 36
Chapter 5: Using the Command Line Interface
5-2
W
HAT
TO
D
O
N
EXT
From the command-line interface, use the procedures in this manual to (among other things):
• Configure the network card ports, followed by services for the network connections, including Automatic Pro-
tection Switching (APS) for the OC3 card.
• Configure ATM traffic, including traffic profiles, policing, packet discard, over-subscription, and traffic shaping
for Unspecified Bit Rate (UBR) traffic.
• Set up ATM routing parameters for either IISP (static ATM routing) or Private Network to Node Interface
(PNNI) dynamic ATM routing.
• Set up system ATM configuration, such as signaling characteristics, ATM prefixes and addresses, ATM inter-
faces, and aliases for ATM addresses.
• Configure ATM connections for Permanent Virtual Circuits (PVC's).
• Set up bridging and routing global parameters and sessions over PVC's.
• Set up an IP/Ethernet uplink (bridging and routing over ATM PVC's) using an SCC card.
Use
to navigate command menus and perform the necessary actions.