ADC SG-1 - Manual (Page 150)

Chapter 7: Second Level Commands June 30, 2006
7-70 SG1-UM-8500-03
Using the no vrrp command
This command deletes the virtual router configuration in the system.
Usage
no vrrp interface \ [\ ]
Parameter(s)
Table 7-18. no vrrp command parameters
Example(s)
Using the vrrp preempt command
• Executing the vrrp preempt interface command orders a backup system to become active (become the
master) if it is configured to the highest virtual router priority.
• Executing the vrrp preempt interface command on a backup system, which is in a lower priority than the
master, does not change the master and backup activity.
Usage
vrrp preempt interface \
enable
Table 7-19. vrrp preempt command parameters
Host(config)# no vrrp interface
Parameter Description Legal values/range
The interface should be Ethernet or
VLAN. Ethernet, VLAN
Slot number. 0, 1
Physical port number. 1 to 3
VLAN ID number.
Virtual Router Group Number (VRID). 1 to 15
Host(config)# no vrrp interface Ethernet 0\1 1
Host(config)# vrrp preempt interface
Parameter Description Legal values/range
The interface should be Ethernet or
VLAN. Ethernet, VLAN
Slot number. 1, 1
Physical port number. 1 to 3
VRRP router priority value. 1 to 254