ADC SG-1 - Manual (Page 40)

Chapter 6: First-Level Commands June 30, 2006
6-4 SG1-UM-8500-03
These commands are discussed below.
Using the show version command
Enter show version to see version levels of hardware and software.
Usage
show version
show version software
show version hardware <2>
Parameter(s)
The first-level parameter has three options:
• software–Displays the software version of the SCC in question.
• hardware–Displays hardware information of the SCC in question.
• pack–Displays detailed information of the installed software version.
The software version for the Service Creation Card in question.
<2>
Module number.
Host> show version