ADC SG-1 - Manual (Page 33)

June 30, 2006 Chapter 4: Accessing the Command Line Interface
SG1-UM-8500-03 4-3
Parameter(s)
\
The SCC and rear I/O interfaces have specific designations as shown in Table 4-2 .
Table 4-2. Interface Identification
The SCC IP address for interface in question. This address is set up to be on the same subnet as the Ethernet
network to which the SG-1 system is attached (format xxx.xxx.xxx.xxx).
The subnet mask associated with the SCC IP address. This address is based on the Ethernet network to which the
SG-1 system is attached (format xxx.xxx.xxx.xxx).
Table 4-3. Ethernet Mode
Example(s)
Card/Type Slot/Port 1 Slot/Port 2
Rear I/O 1/1 1/2
Gigabit Ethernet 1/1 1/2
ATM/GiG-E Card
ATM 2/1 2/2
GiG-E 1/1 1/2
Value Explanation
10H 10M half-duplex
10F 10M full-duplex
100H 100M half-duplex
100F 100M full-duplex
1000H 1000M half-duplex
1000F 1000M full-duplex
Auto Auto select mode
Host> configure terminal
Host(config)# interface ethernet 0 \ 2 12.3.66.211 255.255.255.0 auto mtu 1500
Added Item