ADC SG-1 - Manual (Page 124)

Chapter 7: Second Level Commands June 30, 2006
7-44 SG1-UM-8500-03
Using the lcp echo command
This command configures the LCP echo behavior in all PPP sessions.
• The system default LCP configuration is off.
• The system LCP echo retries value is 3.
• The lcp on default is 30 seconds. In this mode the LCP echo is active for all PPP sessions.
Usage
lcp echo [on [] | off]
Parameter(s)
[on]
This sets lcp echo to active.
[off]
This sets lcp echo to inactive.
This is the lcp echo period in seconds; valid number range is 2 to 32767.
Example(s)
Host(config)# lcp echo
Host(config)# lcp echo on 89