ADC SG-1 User Manual
Page 95
Chapter 7: Second Level Commands
7-15
Usage
port sonet
Parameter(s)
The line card slot to be configured. Use the value 2 to indicate the configuration of the SONET/SDH port.
The line card port to be configured (either 1 or 2).
(OC3c|STM)
The type of physical interface:
• OC3c–the North American standard for 155.52 Mbps data over optical fiber.
• STM–the standard for 155.52 Mbps data over optical fiber outside of North America.
Example(s)
Configuring SONET/SDH port redundancy
SG1 systems use APS to switch ATM traffic from the main SONET/SDH channel (the working channel) to a
secondary SONET/SDH channel (the protection channel on the same card) when a failure occurs. This redundancy
enables service to continue despite failures on the working SONET/SDH channel. Refer to the
System Technology
and Applications Overview
for an explanation of how an APS works.
Usage
port sonet redundancy-enable
Parameter(s)
The slot number to be designated as the working slot (valid value = 2).
The port number to be designated as the working port (valid value = 1 or 2).
The slot number to be designated as the protect slot (valid value = 2).
Host(config)# port sonet 2 \ 1 type OC3C
Updated item
Host(config)#
Host(config)# port sonet redundancy-enable