ADC SG-1 - Manual (Page 11)

SG1-UM-8500-03 xi
A
BOUT
T
HIS
M
ANUAL
I NTRODUCTION
This manual applies to ADC's Service Gateway (SG) system, hereafter referred to as "SG-1." This document
includes an overview of the platform, installation procedures, and an SG-1 commands reference.
O
RGANIZATION
This manual includes the following chapters:
I NTENDED A UDIENCE
This manual is intended for anyone needing to operate, administer, or maintain ADC’s line of Service Creation
Gateway products.
Chapter Description
Chapter 1: Overview Details features and pre-installation requirements for the SG-1
platform, including site requirements for power and cabling.
Chapter 2: Installation Provides detailed procedures for installing SG-1.
Chapter 3: Command-Line Interface (CLI) Describes the SG-1 Command-Line Interface (CLI), the steps to
access the CLI, and the steps to perform initial configuration
using the CLI.
Chapter 4: Accessing the Command Line
Interface Details how to log on locally to an SCC or rear I/O port (if a rear
I/O card option is used) and set an IP address to allow for remote
management via a Telnet session.
Chapter 5: Using the Command Line Interface Describes how to access the command-line interface; it also
directs you to other manuals for administering, configuring, and
managing the SG-1.
Chapter 6: First-Level Commands Defines the commands available at the first command level of
each SCC.
Chapter 7: Second Level Commands Defines commands available at the second command level.
Appendix A: SG-1 Vendor-Specific Attributes Describes the vendor-specific attributes related to SG-1 EDS
architecture.
Appendix B: Redirection Server Explains how ADC’s product redirects all peers’ HTTP requests
to their personal sites as predefined in the Radius Server.
Appendix C: Product Support Provides information on how to contact the ADC Technical
Support group.
Glossary Defines abbreviations and acronyms for the SG-1 Service
Gateway system.