beautypg.com

Chassis ground and power cabling, Network cabling, Configuration port cabling – ADC SG-1 User Manual

Page 19

background image

June 30, 2006

Chapter 1: Overview

SG1-UM-8500-03

1-7

Chassis Ground and Power Cabling

The recommended cabling to ground the SG-1 chassis is 6 AWG (minimum) stranded copper wire.

For the SG-1 chassis, the recommended cabling is 14 AWG (1.88 mm diameter) stranded copper or 14 AWG (1.628
mm diameter) solid wire to connect the DC terminal block to the facility provided power.

For the SG-1 chassis power cable, use one of the following:

• PC US for North America

• PC EURO for Europe

• PC UK for the United Kingdom

Network Cabling

Network connectors interface the SG-1 to an ATM backbone network, a LAN, or a WAN.

Configuration Port Cabling

In addition to the RJ-45 craft port provided on the front panel of each SCC card, each card may have a rear access
RS-232 interface through a RJ-45 connector for craft access and configuration if a Rear I/O card is installed. There
are two Ethernet ports located on the Rear I/O card.

Note:

The Rear I/O card is optional when used with an ATM or Gigabit SCC.