ADC SG-1 - Manual (Page 102)

Chapter 7: Second Level Commands June 30, 2006
7-22 SG1-UM-8500-03
[OAM]
Operation And Management mode
• on - Enable OAM mode
• off - Disable OAM mode
• on-cc - Enable OAM mode with continuity check
Example(s)
RADIUS C OMMANDS
Configuring the RADIUS server in the SG-1 configuration
Each RADIUS server should be configured in the system. The radius-server command is used to configure the
RADIUS server settings.
Usage
radius-server
Parameter(s)
There are two options for the first command-line argument:
• host–to configure the RADIUS server host parameters (see “Configuring the RADIUS server host” below)
• key–to define an alphanumeric string, which serves as a password for communicating with the
RADIUS server
Configuring the RADIUS server host
The host parameters include the IP address of the RADIUS server, the authentication port, the accounting port, and
the type of RADIUS server. The default authentication port is 1645, and the default accounting port is 1646. The
RADIUS server can be defined as one of three types.
• Merit
• Infovia
• Standard (default)
Usage
To set the host parameters of the RADIUS server:
radius-server host auth-port acct-port
priority
To set the RADIUS server key:
radius-server key
Host(config)# atm pvc range 2 34 38 1 \ 2 \ 65 name arttt oam on ubr 120
Host(config)# radius-server
Host(config)# radius-server host