ADC SG-1 - Manual (Page 138)

Chapter 7: Second Level Commands June 30, 2006
7-58 SG1-UM-8500-03
Example(s)
Using the no ip ospf interface command
This command disables OSPF on an interface.
Usage
no ip ospf interface \
[\]
For parameters and examples, refer to “Using the ip ospf interface command” on page 7-57 .
Using the ip ospf interface hello-interval command
This command specifies the interval time in seconds between hello packets.
Usage
ip ospf interface \
[\] hello-interval
Parameter(s)
The time interval between hello packets.
For additional parameters, refer to “Using the ip igmp proxy command” on page 7-51 .
Example(s)
Using the no ip ospf interface hello-interval command
The command sets the interval time between hello packets to its default value.
Usage
no ip ospf interface \
[\] hello-interval
For parameters and examples, refer to “Using the ip ospf interface hello-interval command” .
Host(config)# ip ospf interface Ethernet 1 \ 2 area 12.3.5.6
Host(config)# ip ospf interface ATM 2 \ 1 \ 32 area 12.5.45.8
Host(config)# ip ospf interface VLAN 1 \ 2 \ 33 area 44.55.2.15
Host(config)# no ip ospf interface
Host(config)# ip ospf interface ... hello-interval
Host(config)# ip ospf interface Ethernet 1 \ 2 hello-interval 22
Host(config)# ip ospf interface ATM 2 \ 1 \ 44 hello-interval 32
Host(config)# ip ospf interface VLAN 1 \ 2 \ 33 hello-interval 23
Host(config)# no ip ospf interface ... hello-interval