Sg-1 vendor-specific attributes, Overview, Vendor-specific attributes table – ADC SG-1 User Manual
Page 159: Appendix a: sg-1 vendor-specific attributes, Aappendix, Sg-1 v, Endor, Pecific, Ttributes
A-1
A
Appendix
SG-1 V
ENDOR
-S
PECIFIC
A
TTRIBUTES
This appendix describes the vendor-specific attributes related to SG-1 EDS architecture.
O
VERVIEW
The vendor-specific attributes are based on RFC-2865 RADIUS recommendation. The first 4 octets are the vendor
id (supported vendor ID 2454, 2014). The next two octets are the vendor-type and length as recommended in the
RFC.
The attributes are split into the following groups:
• User
• DHCP
• protocol
• service
• route
• vpdn
• qos
• DNS
Vendor-Specific Attributes Table
When the system sends a vendor-specific attribute to the radius, it sets the vendor type with the attribute internal
number, as specified below in the vendor-specific attribute list (
).
Table A-1. Vendor-Specific Attribute List
Num
Attribute Name
Attribute
Group
Attribute
Value (1 byte
which takes
value of
1 to 255)
First
Introduced
Description
1
accounting
user
10
V5.0
Allows defining the session
accounting operation mode and
methodology.
2
orig-name
user
12
V5.0
Contains the original user name as
received during PPP negotiation.
3
auth-type
user
13
V5.0
Contains the authentication type of
the Access Request message. It
provides the RADIUS with additional
information regarding the purpose of
the authentication.
4
action
user
14
V5.0
Defines the action that should be
taken by the system.
5
SSC-host
user
15
V5.0
Contains the SSC (Service
Selection Center) host IP address at
which the user activated the service.