Campbell Scientific CR3000 Micrologger - Manual (Page 493)

Appendix A. CRBasic Programming Instructions
493
CDM_VW300Config
Configures the CDM_VW300 Dynamic Vibrating Wire Module.
Syntax
CDM_VW300Config(DeviceType, CPIAddress, SysOptions,
ChanEnable, ResonAmp, LowFreq, HighFreq, ChanOptions,
Mult, Offset, SteinA, SteinB, SteinC, RF_MeanBins,
RF_AmpBins, RF_LowLim, RF_HighLim, RF_Hyst, RF_Form)
CDM_VW300Dynamic
Captures dynamic vibrating‐wire sensor readings from the CDM_VW300.
Syntax
CDM_VW300Dynamic(CPIAddress, DestFreq, DestDiag)
CDM_VW300Rainflow
Obtains rainflow histogram data from the CDM_VW300.
Syntax
CDM_VW300Rainflow(CPIAddress, RF1, RF2, RF3, RF4, RF5, RF6,
RF7, RF8)
CDM_VW300Static
Captures static vibrating‐wire sensor readings from the CDM_VW300.
Syntax
CDM_VW300Static(CPIAddress, DestFreq, DestTherm, DestStdDev)
CPISpeed
Controls the speed of the CPI bus.
Syntax
CPISpeed(BitRate))
MuxSelect
Selects the specified channel on a multiplexer.
Syntax
MuxSelect(ClkPort, ResPort, ClkPulseWidth, MuxChan, Mode)
SDMAO4
Sets output voltage levels in an SDM‐AO4 analog output device.
Syntax
SDMAO4(Source, Reps, SDMAdress)
SDMAO4A
Sets output voltage levels in an SDM‐AO4A analog output device.
Syntax
SDMAO4A(Source, Reps, SDMAdress)
SDMCAN
Reads and controls an SDM‐CAN interface.
Syntax
SDMCAN(Dest, SDMAddress, TimeQuanta, TSEG1, TSEG2, ID,
DataType,