beautypg.com

3 pc200w software setup – Campbell Scientific CR3000 Micrologger User Manual

Page 45

background image

Section 4. Quickstart Tutorial

45

 

5. Attach the black wire from the PS100 to the terminal labeled G on the green

connector.

6. After confirming the correct polarity on the wire connections, insert the green

power connector into its receptacle on the CR3000.

7. Connect the RS-232 cable between the RS-232 port on the CR3000 and the

RS-232 port on the PC (or to the USB-to-RS-232 cable).

8. Move the on/off switch on the PS100 to the On position.

Figure 14: Power and RS-232 connections (internal-power supply)

4.2.3 PC200W Software Setup

1. Install the PC200W software onto a PC. Follow on-screen prompts during the

installation process. Use the default program and destination folders.

2. Open the PC200W software (figure PC200W Main Window

(p. 46)

). When the

software is first run, the EZSetup Wizard will run automatically in a new
window. This will configure the software to communicate with the CR3000.
Table PC200W EZSetup Wizard Example Selections

(p. 46)

indicates what

information needs to be entered on each screen. Click Next at the bottom of
the screen to advance to the next screen.

See More!
http://www.youtube.com/playlist?list=PL9E364A63D4A3520A&feature=plcp