Campbell Scientific CR3000 Micrologger - Manual (Page 490)

Appendix A. CRBasic Programming Instructions
490
A.5.9 Specific Sensors
ACPower
Measures real ac power and power‐quality parameters for single‐, split‐, and
three‐phase 'Y' configurations.
Syntax
ACPower(DestAC, ConfigAC, LineFrq, ChanV, VMult, MaxVrms,
ChanI, IMult, MaxIrms, Reps)
DANGER ac power can kill. User is responsible for ensuring connections to ac
power mains conforms to applicable electrical codes. Contact a Campbell
Scientific applications engineer for information on available isolation
transformers.
CS110
Measures electric field by means of a CS110 electric‐field meter.
Syntax
CS110(Dest, Leakage, Status, Integ, Mult, Offset)
CS110Shutter
Controls the shutter of a CS110 electric‐field meter.
Syntax
CS110Shutter(Status, Move)
CS616
Enables and measures a CS616 water content reflectometer.
Syntax
CS616(Dest, Reps, SEChan, Port, MeasPerPort, Mult, Offset)
CS7500
Communicates with the CS7500 open‐path CO
2
and H
2
O sensor.
Syntax
CS7500(Dest, Reps, SDMAddress, Command)
CSAT3
Communicates with the CSAT3 three‐dimensional sonic anemometer.
Syntax
CSAT3(Dest, Reps, SDMAddress, CSAT3Cmd, CSAT3Opt)
EC100
Communicates with the EC150 Open Path and EC155 Closed Path IR Gas
Analyzers via SDM.
Syntax
EC100(Dest, SDMAddress, EC100Cmd)
EC100Configure
Configures the EC150 Open Path and EC155 Closed Path IR Gas Analyzers.
Syntax
EC100Configure(Result, SDMAddress, ConfigCmd, DestSource)