Campbell Scientific CR3000 Micrologger - Manual (Page 492)

Appendix A. CRBasic Programming Instructions
492
A.5.9.1 Wireless Sensor Network
ArrayIndex
Returns the index of a named element in an array.
Syntax
ArrayIndex(Name)
CWB100
Sets up the CR3000 to request and accept measurements from the CWB100
wireless sensor base.
Syntax
CWB100(ComPort, CWSDest, CWSConfig)
CWB100Diagnostics
Sets up the CR3000 to request and accept measurements from the CWB100
wireless sensor base.
Syntax
CWB100(ComPort, CWSDest, CWSConfig)
CWB100Routes
Returns diagnostic information from a wireless network.
Syntax
CWB100Diagnostics(CWBPort, CWSDiag)
CWB100RSSI
Polls wireless sensors in a wireless‐sensor network for radio signal strength.
Syntax
CWB100RSSI(CWBPort)
A.5.10 Peripheral Device Support
Multiple SDM instructions can be used within a program.
AM25T
Controls the AM25T Multiplexer.
Syntax
AM25T(Dest, Reps, Range, AM25TChan, DiffChan, TCType, Tref,
ClkPort, ResPort, VxChan, RevDiff, SettlingTime, Integ,
Mult, Offset)
AVW200
Enables CR3000 to get measurements from an AVW200 Vibrating Wire Spectrum
Analyzer.
Syntax
AVW200(Result, ComPort, NeighborAddr, PakBusAddr, Dest,
AVWChan, MuxChan, Reps, BeginFreq, EndFreq, ExVolt,
Therm50_60Hz, Multiplier, Offset)