HP Radio Frequency Planner Software Series - Manual (Page 88)

Table of Contents
HP RF Planner User Guide
81
called system generated points and the placement of these points depends on various factors like location of floor objects, their
material type, and so on. This view helps you fine tune the current predictions closer to real life values. For this, Planner needs
to collect signal strength values at various places.
Note: Calibration View is not available for outdoor planning.
Figure 102. Calibration View: Indoor Layout
To take readings, move to a location on the floor and double-click the location point. Planner will automatically collect the
signal strength and average it over a period for stable readings. You can also take readings at any location by right-clicking
that point and selecting <Take Reading>.
Figure 103. Visible AP Info List
Select the desired AP’s signal strength and click <OK>. This creates a user-defined point.