Modify sensor model – HP Radio Frequency Planner Software Series User Manual

Page 46

Table of Contents

HP RF Planner User Guide

Add Sensor Properties

Description

Manufacturer

Enter the name of the manufacturer.

Model

Enter the Sensor model.

Available Radio

Select the radio from the drop-down list of available radios.

Add Radio

Click to add a new radio to the Sensor. This takes you to the Radio

Properties section.

Delete Radio

Click to delete a radio.

Antenna

Select the antenna type from the drop-down list.

Click to select or add a new antenna. For details, refer to the

section.

Antenna Detachable

Select the checkbox, depending upon the type of antenna required.

Protocols

Select any or all the protocols (802.11a, 802.11b, 802.11g, 802.11a/n,

802.11b/g/n).

Waterfall Curve

Select the waterfall curve for the protocols from the drop-down list. For

details, refer to the

section.

Power

Specify the desired power range for each protocol. Enter a comma-separated

list with values in the range (1 to 100 mW).

Advanced Parameters

Click to define advanced 802.11n parameters. Refer to the

for more details.

Modify Sensor Model

Click <Modify> on the Sensor Repository dialog box to modify an existing Sensor model. The Modify Sensor Model dialog
box appears.

Figure 46.

Sensor Repository – Modifying a Sensor

The Modify Sensor Model dialog box is similar to the Add Sensor Model dialog box.