HP Radio Frequency Planner Software Series - Manual (Page 110)

Table of Contents
HP RF Planner User Guide
103
Figure 137. Report Details
You cannot edit the Work Order Number and Customer Name fields from this screen. However, you can edit the
following details of the report:

Location Name: Specify the desired name of the building
 Address 1, Address 2: Specify the desired address of the layout
 City: Specify the city where the layout is located
 State: Specify the state where the layout is located
 Postal Code: Specify the postal code of the place where the layout is located
 Country: Specify the country where the layout is located
Click <OK> to save the changes. Alternately, click <Cancel> to discard the changes.
• Report Options: Select the options that you want Planner to include in the Report.

BoM: Select to include the Bill of Material.
 Introduction: Select to add an introduction on WLAN to the overall report.
 Compliance Report: Select to generate a compliance report for devices, mentioning device configuration.
 WLAN Planning Reports: Select to include a complete set of RF maps. This enables you to select the following
WLAN Planning options in the report.

RF Maps: You can select one or more of the available views for the following:

AP Views
 Sensor Views
 Protocols
 Layout Options: Planner generates a report for one of the below specified layouts:

Current Layout
 All Layouts
 Selected Layout(s): Select the checkbox of the desired layout.
 Statistics Option: Select to view the statistics for the following options:

All Defined Area
 Only Selected Area
 Area not Covered by Defined Area
 Complete Layout