HP Radio Frequency Planner Software Series - Manual (Page 43)

Table of Contents
HP RF Planner User Guide
36
Add AP Properties Description
Manufacturer Enter the name of the manufacturer.
Model Enter the AP model.
Available Radio Select the radio from the drop-down list of available radios.
Add Radio
Click to add a new radio to the AP. This takes you to the Radio Properties
section in the dialog box.
Delete Radio Click to delete a radio.
Antenna Select the antenna type from the drop-down list.
More
Click to select or add a new antenna. For details, refer to the Antenna
Repository section.
Antenna Detachable Select the checkbox, depending upon the type of antenna required.
Protocols
Select any or all the protocols (802.11a, 802.11b, 802.11g, 802.11a/n,
802.11b/g/n).
Waterfall Curve
Select the waterfall curve for the protocols from the drop-down list. For
details, refer to the Waterfall Curve Repository section.
Power
Specify the desired power range for each protocol. Enter a comma-separated
list with values in the range (1 to 100 mW).
Advanced Parameters
Click to define advanced 802.11n parameters. The IEEE 802.11n advance
parameters dialog box appears.
IEEE 802.11n Advanced Parameters
You can describe advanced parameters for 802.11n.
Figure 42. Adding an AP – 802.11n Advance Parameters
Define the desired 802.11n advance parameters.
• MIMO configuration: Select the MIMO configuration from the drop-down list
• Channel width (MHz): Select the Channel width from the drop-down list
• Guard interval (ns): Select the Guard interval from the drop-down list
• Frame Aggregation: Select either AMSDU or AMPDU, or both checkboxes for frame aggregation.
For more details on the advance parameters, refer to Appendix D: Glossary of Terms .