HP Radio Frequency Planner Software Series - Manual (Page 58)

Table of Contents
HP RF Planner User Guide
51
5.5.9 Location Properties
You can change the Location Properties from the Tools menu.
Location Properties: Dimensions Tab
The Dimensions tab allows you to change the dimensions of the layout.
Figure 62. Changing Location Properties – Dimensions Tab
Specify the following dimensions and properties:
• Unit: Select the unit of measurement from the drop-down list.
• Length in ‘a’ direction: Specify the length to be used for all layouts in the plan.
• Length in ‘b’ direction: Specify the width to be used for all layouts in the plan.
• Lock Aspect Ratio: Select the Lock Aspect Ratio checkbox, if you want to maintain the ratio of the dimensions of the
layout to that of the layout image.
• RF Calculation Cell Size: Specify the RF calculation cell size to determine the size of the smallest unit on the layout.
Planner performs calculations for each cell on the layout.
• Reset Cell Size: Click to get optimal cell size number for the layout dimensions entered.
• Ceiling Loss: Specify the loss occurring for the cross floor radiation due to the ceiling. The range is -50 to 0.
• Region: Select the region from the drop-down list.
Note: Changing the length and width of the plan resizes the entire set of objects in the layout model. Planner resizes the objects in the same
proportion in which the size of the plan is changed. Changing these units will affect the dimension values and coverage.
During resize, if there are any objects like Polygons or Area Polygons placed on the floor map, Planner deletes these objects because it
cannot resize them.
These changes affect all the layouts in the plan. In case you want to plan multiple floors with different dimensions, enter the largest floor
dimensions and then plan for smaller areas for each floor.