HP 8.20q Fibre Channel Switch - Manual (Page 72)

72 Managing Switches
NOTE: IPsec policies must be unique. The unique key for a policy includes the fields Source
Address, Source Port, Source Prefix Length, Destination Address, Destination Port, Destination Prefix
Length, Protocol, ICMP IPv6 Type (if specified), and Direction. No two IPsec associations can
contain duplicate values in these nine fields.
4. To save the new IPsec policy and close the IPsec Policy dialog box, click OK. To abandon creation of
the IPsec policy, click Cancel.
5. When you are through managing security policies, select one of the following options:
• To save your changes and close the IPsec Configuration dialog box, click OK.
• To close the IPsec Configuration dialog box without saving any changes, click Cancel.
CAUTION: Be aware that if you click Cancel on the IPsec Configuration dialog box, all changes you have
made to IPsec associations and policies are revoked. That is, all associations and policies that you have
created, edited, deleted, copied, or pasted while the IPsec Configuration dialog box was open are
nullified.
Editing an IPsec policy
To edit an IPsec policy:
1. On the Adapter & Switch Management menu, click Set Switch IPsec Information. (If you have more than
one switch in your SAN, the Switch Selection dialog box prompts you to select a switch, and then click
OK.)
The IPsec Configuration dialog box opens (see
Figure 41 on page 69) and lists the existing IPsec
Associations on the left and the existing IPsec Policies on the right.
2. Under IPsec Policies, select the policy that you want to modify, and then click Edit.
The IPsec Policy dialog box opens (
Figure 42 on page 70).
3. Modify the existing security policy settings, and then click OK to save your changes. (For an
explanation on each of the fields on the IPsec Policy dialog box, see “Creating an IPsec policy,”
page 69.)
4. When you are through managing security policies, select one of the following options:
• To save your changes and close the IPsec Configuration dialog box, click OK.
• To close the IPsec Configuration dialog box without saving any changes, click Cancel.
CAUTION: Be aware that if you click Cancel on the IPsec Configuration dialog box, all changes you have
made to IPsec associations and policies are revoked. That is, all associations and policies that you have
created, edited, deleted, copied, or pasted while the IPsec Configuration dialog box was open are
nullified.