HP 8.20q Fibre Channel Switch - Manual (Page 115)

HP SAN Connection Manager User Guide 115
9 Viewing VCEM and c-Class Enclosure Properties
This chapter provides procedures for viewing VCEM version 6.1 or later and c-Class Enclosure properties
using SAN Connection Manager.
Supported configurations
• VCEM 6.1 or later and Virtual Connect Manager configured to the recommended HP guidelines (all
servers and SAN fabrics configured correctly and the VCM managed by VCEM)
NOTE: HP recommends that VCEM 6.1 or later is installed on a different server from the SCM
management station.
• For SAN fabrics, SCM supports both factory default and VC WWN addresses. With VC defined
WWN addresses, additional host to blade/bay associations are available.
Viewing VCEM information
SAN Connection Manager provides easy access to information about VCEM within your SAN. Use the
VCEM Configuration dialog box to establish associations between each blade and their respective HP
BladeSystem c-Class Enclosure.
To log in and view VCEM configuration:
1. Start the SAN Connection Manager. See “Starting SAN Connection Manager” on page 32.
2. Open the VCEM Configuration dialog box ( Figure 85 ).
3. Check in the Enable VCEM Discovery check box.
4. Enter the username and password, and then enter the IP address of the VCEM host server.
5. Click OK.
Figure 85 SCM VCEM Configuration