beautypg.com

18 third step of new switch setup completed, 19 welcome… configure your san dialog box, Step 9 – HP 8.20q Fibre Channel Switch User Manual

Page 38

background image

38

Getting Started

11.

Complete the Set the Switch Default Zoning dialog box as follows:

a. In the Default zone set name box, enter a new name for your configuration.
b. To exclude a storage port from the zone, clear the check box next to the port name. To include a

storage port in the zone, select the check box next to it.

c. To save the new switch default zoning setup, click OK. To stop the switch zoning changes, click

Cancel.

The New Switch Setup dialog box shows a check mark next to the third step, “Set switch administrator

password,” (

Figure 18

) indicating that you have completed that task.

Figure 18

Third step of New Switch Setup completed

12.

Click Close to close the New Switch Setup dialog box for this switch.

13.

If SAN Connection Manager detects another unconfigured switch, the New Switch Setup wizard opens

again for that switch and guides you through its setup.
After you have either completed all the steps required in the New Switch Setup procedures (

step 4

through

step 9

), or opted not to set up the switch at this time, the Welcome… Configure Your SAN

dialog box (

Figure 19

) appears.

Figure 19

Welcome… Configure Your SAN dialog box

This manual is related to the following products: