HP 8.20q Fibre Channel Switch - Manual (Page 35)

HP SAN Connection Manager User Guide 35
5. Choose one of the following options:
• To continue with the first step (setting the switch IP address), click OK. The Set Switch IP Address
dialog box ( Figure 13 ) opens. Go to step 6 .
• To skip the switch setup for now, click Cancel. (To set up the switch later, see the procedures in
“Managing Switches,” page 47. If you do not complete switch set up before you exit SAN
Connection Manager, the New Switch Setup dialog box will open again the next time you start the
application.)
The Set Switch IP Address dialog box ( Figure 13 ) shows the switch name and default IP address.
Figure 13 Set Switch IP Address dialog box: new switch setup
6. Select either the Enable IPv4 or Enable IPv6 check box, and then complete the appropriate IPv4 or IPv6
information (for details, see “Setting the switch IP address,” page 54). Click OK.
The New Switch Setup dialog box shows a check mark next to the first step, “Set switch IP address,”
( Figure 14 ) indicating that you have completed that task.
Figure 14 First step of New Switch Setup completed