HP 8.20q Fibre Channel Switch - Manual (Page 11)

HP SAN Connection Manager User Guide 11
2 Installing, Upgrading, and Removing HP SAN
Connection Manager
This chapter provides procedures for installing and upgrading SAN Connection Manager on a Windows
management station, and for installing and upgrading the required software components on other servers.
It also provides procedures for removing SAN Connection Manager from a Windows system, as well as
removing the software components from Linux servers.
Installing SAN Connection Manager: initial installation
Use the HP SAN Connection Manager CD to install the management software on your management
station as described in “Windows installation: initial,” page 12. Then use the same CD to install the HBA
driver and other required software on each of the other servers in your SAN. Depending on the server
operating system for the non-management station installations, refer to either the steps for “Windows
installation: initial,” page 12 or “Linux installation: initial,” page 15.
NOTE: To configure servers using other operating systems or non-QLogic HBAs, see “Configuring SAN
Connection Manager for HP-UX and Emulex HBAs,” page 17.