HP 8.20q Fibre Channel Switch - Manual (Page 70)

70 Managing Switches
2. Under IPsec Policies, click Create.
The IPsec Policy dialog box opens (
Figure 42 ). You must complete all fields prefaced by a red asterisk.
NOTE: SAN Connection Manager allows you to create a maximum of 128 IPsec policies.
Figure 42 IPsec Policy dialog box
3. Complete the IPsec Policy dialog box as follows:
Name Enter a unique alphanumeric name that starts with a letter, does not contain
spaces, and does not exceed 32 characters. You may include the following
special characters: ampersand (&), hyphen (-), circumflex (^), and underscore
(_).
Description (Optional) Enter a description of the IPsec policy.
Source Address Enter either a valid IPv4 address, a valid IPv6 address, or a valid DNS host
name.
Source Port (Optional) Enter a number in the range of 1 to 65535.
Source Prefix Length (Optional) Specify the length of the prefix in the source address by entering a
number in the range of 0 to 64.
Destination Address Enter either a valid IPv4 address, a valid IPv6 address, or a valid DNS host
name of the host, switch, or gateway receiving data. If you entered an IP address
for the Source Address, the Destination Address must use the same IP version
format.
Destination Port (Optional) Specify the destination port number by entering a number in the
range of 1 to 65535.