HP Officejet 6500 - Manual (Page 118)

Figure 8-5 Back view of the device
1 Telephone wall jack
2 Use the phone cord supplied in the box with the device to connect to the
"1-LINE" port
You might need to connect the supplied phone cord to the adapter
provided for your country/region.
To set up the device with voice mail
1. Using the phone cord supplied in the box with the device, connect one end to your
telephone wall jack, then connect the other end to the port labeled 1-LINE on the back
of the device.
You might need to connect the supplied phone cord to the adapter provided for your
country/region.
NOTE: You might need to connect the supplied phone cord to the adapter
provided for your country/region.
If you do not use the supplied cord to connect from the telephone wall jack to the
device, you might not be able to fax successfully. This special phone cord is
different from the phone cords you might already have in your home or office.
2. Turn off the Auto Answer setting.
3. Run a fax test.
You must be available to respond in person to incoming fax calls, or the device cannot
receive faxes. You must initiate the manual fax before voicemail picks up the line.
If you encounter problems setting up the device with optional equipment, contact your
local service provider or vendor for further assistance.
Case G: Fax line shared with computer modem (no voice calls received)
If you have a fax line on which you receive no voice calls, and you also have a computer
modem connected on this line, set up the device as described in this section.
Chapter 8
114 Configure and manage