NORD Drivesystems BU0750 - Manual (Page 57)

4.3 ParameterBox Installation Version, SK PAR-2E
BU 0750 GB-3311 Subject to technical amendments 57
4.2 ParameterBox, Handheld Version, SK PAR-2H
(SK PAR-2H, Part No.: 278910100)
The SK PAR-2H ParameterBox is a compact control device for direct connection to the
SK 750E frequency inverter. A suitable connection cable with an M12 plug contact is
already included with the device. This means that the ParameterBox can be directly
connected to the SK 750E without additional components.
Special connection cables are required for connection to other NORDAC inverters or a
PC/laptop. These are listed in more detail in the ParameterBox instruction manual
BU 0040.
Connection to SK 750E
Connection to the trio SK 750E can be made using the existing
M12 socket. The maximum protection class IP54/65 is retained for
the entire unit by using the special connector components.
After the mains voltage is switched on the corresponding device
type is automatically recognised.
Note:
For further information, please refer to the operating
instructions for the ParameterBox "BU 0040 GB".
M12 plug Description Cable
2 (white) + 5V / 170mA
Length 3m
4 x 0.75mm²
1 (brown) GND
4 (black) P+ (A) RS485 +
3 (blue) P- (B) RS485 -