NORD Drivesystems BU0750 - Manual (Page 3)

NORDAC SK 750E Manual Concerning this document
BU 0750 GB-3311 3
Documentation
Designation: BU 0750 EN
Part No.: 607 75 01
Device series: SK 750E
Version list
Designation of previous issues SW status Comments
BU 0750 GB, December 2004 V 3.1 R1 First issue based on BU 0700 DE
BU 0750 GB, December 2005 V 3.1 R2 Revision, supplementation and correction
BU 0750 GB, April 2006 V 3.2 R0 Revision, wall-mounting kit, motor mounting,
differentiation of the options for IP54 and IP65
version, cable glands
BU 0750 GB, March 2007
Part No.: 6077502 / 1207 V 3.2 R0 Data backup via P550 only right hand slot, Section 3.2
right / left slot
BU 0750 GB, March 2008
Part No.: 6077502 / 1208 V3.4 R4 Control for electromagnetic motor brakes, P217,
P426, P533, P535
BU 0750 GB, August 2011
Part No.: 6077502 / 3311 V3.5 R1 Addition of UL-relevant details; revision of Sections
2.6, 3.3.3, 3.3.4; revision of parameter P208, P215;
P216, function of digital inputs: 47/48;
addition of environmental classes, long-term storage
and min. brake resistances (Section 9)
Publisher
Getriebebau NORD GmbH & Co. KG
Rudolf-Diesel-Str. 1

D-22941 Bargteheide

http://www.nord.com/
Tel.: +49 (0) 45 32 / 401-0

Fax +49 (0) 45 32 / 401-555
Intended use of the
frequency inverter
Compliance with the operating instructions is necessary for fault-free operation and the
acceptance of any warranty claims. These operating instructions must be read before
working with the device!
These operating instructions contain important information about servicing. They must
therefore be kept near to the device .
SK 750E frequency inverters are devices for industrial and commercial plants for operating
three-phase asynchronous motors with squirrel-cage rotors. These motors must be suitable for
operation with frequency inverters, other loads must not be connected to the devices.
SK 750E frequency inverters are devices for fixed installation in control cabinets. All details
regarding technical data and permissible conditions at the installation site must be complied
with.
Commissioning (commencement of the intended use) is prohibited until it has been ensured that
the machine complies with the EMC Directive 2004/108/EEC and that the conformity of the end
product meets the Machinery Directive 2006/42/EEC (observe EN 60204).

Getriebebau NORD GmbH & Co. KG, 2011