NORD Drivesystems BU0750 - Manual (Page 24)

NORDAC SK 750E Manual
24 Subject to technical amendments BU 0750 GB-3311
2.9.7 Control connections (optional)
The manner and type of control unit connections are dependent on the options chosen (customer unit / special
extension unit). The possible variants are described in Section 3.3/3.4.
Here you will find general data and information on all customer units and special extension units.
Connection terminals: - Plug-in clip connectors can be released with a small screwdriver
Maximum
connection cross-section: - 1.5mm
2
or 1.0mm
2
(AWG 26-14 or 26-16), according to option
Cable: - laid separately from the mains/motor cables and shielded
Control voltages:
- 5V, max. 300mA, for the supply of a ParameterBox SK PAR-2H
(Short-circuit proof) - 10V, max. 10mA, reference voltage for an external potentiometer
- 15V, max. 300mA, for the supply of digital inputs or an incremental or
absolute encoder
- analog output 0 - 10V, max. 5mA for an external display unit
NOTE
All control voltages refer to a common reference potential 0V / GND.
If necessary, 5 / 15V can be taken from several terminals. The sum the currents must not exceed
300mA.