NORD Drivesystems BU0750 User Manual
Page 117
BU 0750 GB-3311
Subject to technical amendments
117
Parameter
Setting value / Description / Note
Parameter
set
Available with option
P546
Bus setpoint 1
P
Always visible
0 ... 7
[ 1 ]
In this parameter, a function is allocated to the output setpoint 1 during bus actuation.
Note: Further details can be found in the respective BUS instruction manuals.
0 = Off
1 = Setpoint frequency (16 Bit)
2 = 16 Bit setpoint position (only with option PosiCon, SK 750E)
3 = 32 Bit setpoint position (only with Option PosiCon, SK 750E
and if PPO type 2 or 4 has been selected)
4 = Control terminals PosiCon
3
(only with Option PosiCon, SK 750E, 16Bit)
5 = Setpoint position (16 Bit) increment
2
(only with PosiCon, SK 750E)
6 = Setpoint position (32Bit) increment
2
(only with PosiCon, SK 750E)
7 = Bus I/O In B
its 0 … 7
P547
Bus setpoint 2
P
Always visible
0 ... 20
[ 0 ]
In this parameter, a function is allocated to the output setpoint 2 during bus actuation.
Note: Further details can be found in the respective BUS instruction manuals.
0 = Off
1 = Setpoint frequency
2 = Torque current limit
3 = Actual frequency PID
4 = Frequency addition
5 = Frequency subtraction
6 = Current limit
7 = Maximum frequency
8 = Actual PID frequency
limited
9 = Actual PID frequency
monitored
10 = Torque
11 = Lead torque
12 = Control terminals PosiCon
3
(only with PosiCon option)
13 = Multiplication
14 = Process controller actual value
15 = Process controller setpoint
16 = Process controller lead
17 = Bus IO In Bits 0-7
18 = Curve travel calculator
19 = Set relay (P541)
20 =
Set analog output (P542)
P548
Bus setpoint 3
P
Always visible
0 ... 20
[ 0 ]
In this parameter, a function is allocated to the output setpoint 3 during bus actuation. It is only
present when P546
3.
Note: Further details can be found in the respective BUS instruction manuals.
This parameter is identical to P547.
3
The "reference run", "teach-in" and "reset position" can be controlled via the other Bits:
2
Bit 0: Position array / Position increment array
Bit 1: Position array / Position increment array
Bit 2: Position array / Position increment array
Bit 3: Position array / Position increment array
Bit 4: Position array / Position increment array
Bit 5: Position array / Position increment array
Bit 6: Reference point run
Bit 7: Reference point
Bit 8: Teach-In
Bit 9: Quit Teach-In
Bit 10: Reset position