GW Instek GLC-9000 User Manual - Manual (Page 57)

OPERATION
57
The T2 terminal is high voltage. Avoid contact with the
terminal. The T2 terminal should not be connected
with an earth conductor.
Measurement
Setup Confirm all settings including MD, leakage current
mode, measurement time, upper and lower limits,
and other parameters.
Panel Operation 2. Turn on the circuit breaker.
Connect the EUT to the
power socket.
 GLC-9000
3. Press the START button to
start measurements.
 GLC-9000
4. Press the reset button to
stop measurement.
 GLC-9000
Warning Turn the circuit breaker off before removing the EUT.
Ensure the power consumption of the EUT doesn’t
exceed the rated power limits.