GW Instek GLC-9000 User Manual - Manual (Page 39)

GETTING STARTED
39
2. Insert the power cord as shown on the right
into the EUT AC Line In.
The arrow above shows the EUT AC line in socket,
located on the left-hand side of the rear panel.
Caution If network B (MD B) is selected an isolation
transformer that outputs 110% of the rated voltage
specified for the EUT is required. The neutral line
must be grounded (from the secondary side of the
transformer).
Measurement networks (MD)A, B, C all require an
isolation transformer.
T1/T2/T3
Terminals 1. Insert the test leads to one of the terminals
2. The measuring mode determines which
terminal will be used.
Terminals T1, T2 and T3 are shown above.