Yokogawa Standalone MW100 - Manual (Page 9)

1-2
IM MW100-17E
Sub-Delimiters
• Semicolons ( ; ) are used as sub-delimiters.
• You can enumerate up to 99 commands by connecting them one-by-one with
the sub-delimiter. However, the following commands and queries cannot be
enumerated. Use them solitarily.
• Control commands
• Output commands
• Queries
Terminator
You can use one of the following as the terminator.
• CR + LF (or 0x0d 0x0a in base 16 ASCII code. )
• LF (or 0x0a in base 16 ASCII code.)
Note
• Commands must be kept within 2047 bytes from the first character to the terminator.
• Except for user-specified strings, commands are not case-sensitive.
• Even if a command enumerated with other commands experiences and error, the other
commands are all executed.
Response
The instrument receives a single response (affirmative or negative) for every command
delimited with a terminator.* Please maintain a 1-to-1 command-response ratio on the
controller side as well. If this command-response format is not upheld, correct operation
cannot be guaranteed. For the format of responses, see section 2.1.
* There are exceptions with RS-422A/485 specific commands (see section 2.1).
1.1 Command Format