Yokogawa Standalone MW100 - Manual (Page 144)

App-42
IM MW100-17E
Click Next to accept defaults until returned to this screen and then check Continue
creating more message destinations and Next.
Message Destinations (Slaves)
Now it is time to route communications to the MW100. In this case, all write and read
commands issued from the SLC504 in this example are sent to Node 5 (it could be set to
read or write to any other address). If the SLC is going to write to devices with different
addresses, then confine the address to just the address of the specific MW100. In this
example the IAP will route any message with an address of 5 to 255 to the MW100. Click
Next to continue.
Message Destination Addresses
Appendix 9 Detailed Configuration of DigiOne IAP Serial Gateway