ZOLL E Series Monitor Defibrillator Rev M - Manual (Page 12)

Chapter 1 Introduction
6 9650-1201-01 Rev. M
Accessing and Changing Configuration Parameters
You can change the current value for any configuration parameter. You access most of the
parameters in the same way as described below. Additional steps are required to access and
modify several parameters. For those parameters, there are additional steps provided with the
parameter description in the next chapter.
Procedure
Follow these steps to access the parameters.
Leaving Configuration Mode
If you press the Exit Config softkey on the Main System Configuration screen, the unit
prompts you to save or discard any changes. Select the appropriate option, and then press the
Enter softkey.
Step Action
1. Press the Change Config softkey from the Main
System Configuration screen.
The unit advances to the Parameter Categories
screen.
2. Use the softkeys on the screen to scroll through
and select a category, or exit as follows:
• Prev Item, Next Item — moves the highlight
back and forth through the list of categories.
• Enter — provides you access to the options of
the highlighted category.
• Return — returns you to the Main System
Configuration screen.
3. Once you select and access the options for a
category, highlight the specific parameter you
want to change, and press the Change Value
softkey until the appropriate value is displayed.
4. When you are finished, you can either press the
Return softkey to return to the Category screen,
or press the Prev Item or Next Item softkey to
move to another category whose parameters you
want to modify.
Enter Return
Next
Item
Prev
Item
System Configuration
1 of 7
ECG
Tones
Set/Review
General Set/Review
Set/Review