FEC MICRO NR - Manual (Page 96)

Chapter 7: System Operations
Page 7-28
7.4.7 Memory Card Abnormal Display / Edit mode
After enter [PESET EDIT MODE], current selection is blinking at [DATA] field.
Use [
 ] and [  ] buttons to select desire mode.
Turn MNR controller power OFF and ON after this mode change.
Abnormal detect effective
Abnormal detect Invalid
Memory card abnormal detection effective:
The unit outputs and displays abnormal when an abnormal condition occurs.
Memory card abnormal detection Invalid:
The unit will not output and display abnormal when an abnormal condition occurs.
Fastening operation will continue and may not store result data.
7.4.8 Torque Unit / RS232C / Memory Card Data Update Confirmation
After [MODE] button is pressed, use [  ] and [  ] buttons to select YES or NO; YES means that the
data will be saved if the confirmation [SET] button is pressed. NO means that the data will not be
saved.
Note
[  ] [  ]
buttons
 New data will not store when Power is turned OFF during edit mode.
 Turn power OFF and ON after changing RS232C Mode to complete process.
 All parameter data will clear when the Torque Unit is changed.
MODE 

SET
RS232 preset update